Algodoo

Welcome to the user manuel of the ASR (Algodoo Sniper Rifle) Mk. IV!

This is a fully custom made high-power sniper rifle, capable of firing 48.25 kilogram bullets at over 2000m/s while maintaining a very high reliability rate,

This weapon is the easiest to reload yet from my ASR series, with only a couple steps required to get the gun to function after firing, however, there are still several notes to keep in mind while using this, so make sure to read everything!

NOTE (1/2): There is already a round in the Chamber, so to reload, first fire the round by pressing RETURN until the bullet is expelled. The firing key can be rebound by changing the motor back key on the large axle located in the middle of the ORANGE Firing Hammer just behind the Chamber on the Recoil Block,

Note (2/2): During weappon usage, it is reccomended to switch into view mode by pressing SHIFT and SPACE to disable most tool hotkeys and clear the screen of settings panels,

RELOADING:
1. Press L once and wait for the gun to tilt all the way up until the Shoulder Rest hits the ground. The Support Leg should also have flipped up,

2. Pull the BLUE bolt down until the empty shell is ejected. Make sure the gun's orientation doesn't change while you do this, not that it's a requirement, just that it's easier to reload without the Magazine jerking around,

3. Once the shell is clear of the Chamber and the Recoil Block, release the BLUE bolt and let the new shell be forced into place. The Recoil Block should be all the way forwards again,

4. Press L again, which should cause the Support Leg the extend and the gun to fall back into firing position,

5. You are ready to fire! Press RETURN and the ORANGE Firing Hammer should rise and strike the bullet. If a misfire occurs and the bullet's propulsion springs do not disconnect or the bullet gets lodged sideways in the barrel, all that must be done is cut or delete the springs and pull the bullet out of the barrel. Afterwards, reload as normal.