Algodoo

This, is good. Hard, puzzling, and most importanly, addicting.

Very well done.

Phun compatible?

This is not WWII at all, it barely looks like a gun.

I'm new to Algodoo, I just switched from Phun, but thanks for the suggestions, I'll fix it now.

This is extremely overrated.

It's not a trick, but I take the area just in front of the bullet, and load it into the middle of the handguard and pull up & right to load it.

Would it be possible for me to make a vehicle skin or something like that, and you make an engine to replicate realistic acceleration/top speed? I have trouble making proper engines, I don't even know how.

Or at least can I use this in one of my cars?

For the engine I'm requesting, I'm planning on building a 1966 Chevy Nova. The engine specs I read on the internet are as follows: 0-60 MPH = 5.8 seconds, 0-100 MPH = 12.8 seconds, and it does a 1/4th mile in 14 seconds. The top speed is around 115 MPH.

This seems like a tad hefty request, so if you do it, thanks!

I set the hinge to it's current speed to simulate the actual speed and gearage of the Cuda, it goes at about the same top speed as the real Cuda.

Poorly made, with no resemblance to an actual M249 S.A.W. at all.

Meer, I did give him credit in my V1. Please check the original versions first.

Firping pin can be pulled out: So?
Free Floating: So?
Spring Loaded Bolt: I made this in phun a long time ago.