Algodoo

CONTROLS:

up - throttle up
down - breaks
left - reverse
i - ignition
alt - toggle clutch
crtl - lock front tire
j - lock rear tires
1, 2, 3, 4, 5 - gears

INSTUCTIONS:
Step 1: Press "i" to start the engine, it should idle at aroun 700-800rpm

Step 2: Make sure you are in gear "1" before pressing "alt" to engage the clutch

Step 3: Press the "up arrow" to increase the engine RPM, the engine should red line at 2200rpm

Step 4: Once you get going wait until the RPM reaches ~2000-2200rpm before moving to the next gear

Use "j" or "crtl" to allow for better grip during off road

I wanted to prove that a spring powered I6 engine is powerful enough to power a 6.5 ton truck.
As I tested the truck, I had found out that the 0 - 100kph time of the truck was about 10 seconds,
a top speed of 250kph (I think, I forgot, it might go faster than that) and a pretty realistic engine.